Lot 2: Davis Standard Thermatic Extruder 25-IN-25

Davis Standard Thermatic Extruder 25-IN-25 and Control Unit, 2.5” (63 mm) Bore, 24:1 L/D Ratio, Type DSPA, Heavy Duty, Fabricated Steel Base with Rigid Steel Front Barrel Support, Vertically Adjustable Motor Base for 50 HP Drive Motor with Encoder, Belts, Sheaves and Belt Guard for 100 RPM Screw Speed, Heavy Duty Gearbox with 17.56:1 Ratio Utilizing Helical Gearing and Positive Internal Lubrication. Gearbox Rated at 95 HP (71 Kw) at 100 RPM with A 1.25 Service Factor, Pre-Loaded Thrust Bearing with A B-10 Life Of 544,000 Hours at 5,000 PSI (344 BAR) and 100 RPM, Cast Iron Feed Section with Full Water Jacket, Alloy Steel Barrel with DS-6000 Bimetallic Liner, Drilled and Tapped for Pressure Transducer, Cast Aluminium, Single-Phase Heaters with Thermafins, 4 Zones, 7,000 Watts Per Zone, Barrel Hoods are Covered Inside with Foil-Faced Fiberglass, Dynisco Model DST100H-10M-6, 0-10,000 PSI (0 To 690 BAR) Pressure Transducer with Installed in Breaker Plate Area, Located at the 12 o’clock Position, Hinged Head Support Assembly, Heated, Single Swing Bolt Clamp Assembly with Control Thermocouple, Breaker Plate with 3 Sets Of 14, 40 & 60 Mesh Screen Packs, Rupture Disc 9,000 PSI (620 BAR) Installed, Totally Enclosed Non-Ventilated Blower Motors, Blower Assembly, Emergency “E” Stop Mushroom Pushbutton Located at The Feed Throat Opening, Plug Box will use 230 VAC, 15 Amp Twist Lock Plugs for All Die Zones, Stainless Steel Hopper. S/O No. 85941 S/No. BX024 (2008)

Please Note: this lot is located in Swindon and will be loaded free of charge to a suitable vehicle. Blocking and securing will be at the cost of the purchaser.