2913 - Lisec IG Line & Bulsar 830 x 900mm Close Pitch Glass Toughening Plant
Glass
L'enchère s'est terminée le
Temps restant
'Description de l''enchère'
Please Note: These lots are located in Tamworth, West Midlands and will be loaded free of charge to a suitable vehicle. Blocking and securing will be at the cost of the purchaser. All/Any tooling is being offered as specifically described.
Prime d'acheteur
'La prime d''acheteur sera fixée à 18.00%.'
TVA
'La taxe sur la valeur ajoutée s''élèvera à 20.00%.'
Temps de consultation
Viewing will be available by appointment only. Please contact our Office on: +44 (0) 121 328 2424 or email us at: info@cottandco.com to arrange a mutually convenient time.
* Remarque : Toute traduction effectuée à l'aide de Google Traduction n'est pas garantie en tant que traduction exacte et n'est fournie qu'à titre indicatif. La description du lot en anglais est la description prédominante et bénéficie de la meilleure connaissance du commissaire-priseur. Cependant, l'exactitude n'est pas garantie et doit être vérifiée par l'acheteur avant d'enchérir.
Avis aux acheteurs
Date limite de paiement
'Date limite d''apurement'
'Agents d''expédition'
Sous-traitants pour le stockage
Exporter/Importer des détails du Royaume-Uni
Lots 1-2 de 2
Lot 100: Lisec LTR 16VN IG Line
Lisec LTR 16VN IG Line, 1.6m Height x 2.5m Length Glass Processing Capability, Left to Right, Infeed Table, 3 x Brush Washer / Dryer, Assembly / Inspection / Location Table, Power Press, Off-Load Table (2002)
Please Note: This lot is located in Tamworth, West Midlands and will be loaded free of charge to a suitable vehicle. Blocking and securing will be at the cost of the purchaser. All/Any tooling is being offered as specifically described.
Lot 101: Bulsar (Coventry) 830 x 900mm Close Pitch Glass Toughening Plant
Bulsar (Coventry) 830 x 900mm-Close Pitch Glass Toughening Plant, Bedsize: 830mm x 900mm, 45mm Pitch on Rollers, Capable of Tempering Glass 100mm x 50mm, 4 – 10mm Glass, ABB Drive Motors, Mounted on a Steel Frame for easy Installation, Heating Supply - Run by 3 x 163 Amp Fuses, 3 x Top Heating Zones (3 x 40 Amp SSR’s), 1 x Bottom Heating Zone (3 x 25 Amp SSR’s), Cooling Supply - Run by 3 x 63 Amp fuses, TEKO 45 Kw (60 Hp) Motor for Cooling, Run from a Speecon 7200 GA VSD Inverter, Footprint: 5.2m Length x 1.6 m Width x 1.8m Height, Mitsubishi Frenic PLC, 45KW 3-Phase Blower, Drive – Eurotherm 514C Inverter, E200 HMI at Load End (2004)
Please Note: This lot is located in Tamworth, West Midlands and will be loaded ...